Table of Contents
Advertisement
Installation Guide
2.6 External Antenna Model Wall Mount Instructions
A wall mount deployment requires hanging the AP6522 access point along its width or length using the pair of slots
on the bottom of the unit. The AP6522 can be mounted on to any plaster, wood or cement wall surface using the
provided wall anchors.
2.6.1 Wall Mount Hardware
• Two customer provided wide-shoulder Phillips pan head self-tapping screws (M3.5 x 0.6 x 20 mm)
• Two wall anchors (customer supplied)
• Security cable (optional)
NOTE
2.6.2 Wall Mount Procedure - New Installation
This section describes a new AP6522 installation with no previous Access Point existing on the intended wall
surface.
1. Attach the two provided mounting ears (using four ear mounting screws) to the two narrow ens of the
AP6522. Align the ears using the built in ear alignment pin on the Access Point housing. Torque the screws
to 6 lb-in.
The following screws are recommended: (ANSI Standard) #6-18 X
0.875in. Type A or AB Self-Tapping Screw, or (ANSI Standard Metric)
M3.5 X 0.6 X 20mm Type D Self-Tapping Screw.
l e
n s o
C o
o E
1 / P
G E
1 2 V
D C
2 - 1
D I O
R A
1 - 0
D I O
R A
15
Advertisement
Table of Contents
