Motorola MOTOwi4 25600 Hardware Installation page 64

Ground Based Access Point (GAP) Hardware Installation
Refer to Figure 4-2
cabinet or rack mounting brackets.
Figure 4-2 Wooden oor mounting
SMALL FLAT
WASHER
MOUNTING
SMALL FLAT
STRUCTURE
WASHER
(I BEAM)
PRELIMINARY ILLUSTRATION
68P09286A73-1
Due to the weight of the GAP components and rack, the supporting structure (oor
deck) must be able to withstand at least 1000 lbs (500 kg). A structural oor support,
such as an iron I-beam, underneath the wooden oor is recommended.
for a typical cross - section of the wooden floor bolt mounting to the GAP
M12 X 100 BOL T
M12 NUT
PRELIMINARY - UNDER DEVELOPMENT
INSULATING WASHER
(OPTIONAL)
LARGE FLAT
MOUTING
BRACKET
ISOLA TION
PAD
(AFFIXED TO
BRACKETS)
LOCK W ASHER
ti-cdma-05743-wd.eps
Mounting and bolt congurations
JUL 2007
4-7