Tools And Materials; Introduction; Table 1-2 Tools And Materials - Motorola MOTOwi4 25600 Hardware Installation

Ground Based Access Point (GAP) Hardware Installation

Tools and Materials

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

Introduction

Many of the tools and materials depend on the GAP installation, being indoor or outdoor. The
indoor GAP is mounted in a standard 19 - inch rack. The outdoor GAP is installed on a concrete
slab. Tools and materials also depend on the style of the wall or pole on which the RF Head
mounting bracket is being installed. Due to different mounting styles, additional tools and
materials may be required to meet site specific needs.
Tools and Materials
The tools and materials listed in
perform the various installation procedures. Not all tools will be used in all procedures.

Table 1-2 Tools and Materials

Hand Tool
Adjustable Torque ratchet
and metric/standard socket
set
Cordless Power Drill, 3/8-in
or 1/2-in drive
Bucklestrap Cutting Tool
Tape Measure
Tin Snips
Safety Glasses
Knife or Box Cutter
13/16 Breakaway Torque
Wrench 38-in. lb
Crane or industrial fork lift
(must be rated for at least two
ton capacity)
Block and Tackle
No. 2 Blade Screw Driver
68P09286A73-1
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Table 1-2
Materials
Customer Supplied
Appropriate wood and
masonry drill bits (Standard
set may be adequate)
Customer Supplied
(Motorola P/N 6604809N01)
Customer Supplied
Customer Supplied
Customer Supplied
Customer Supplied
Customer Supplied
Customer Supplied
Customer Supplied
Customer Supplied
PRELIMINARY - UNDER DEVELOPMENT
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
are generally recommended to properly and safely
For general torquing of bolts and nuts.
Drill holes in wood and light concrete
For the pole mounting brackets
General purpose measurement
General purpose metal cutting
Eye Safety
General purpose cutting
N Connectors
Used to transport and support for GAP
cabinet(s)
High - capacity, 4 - point cable with hooks or
carabiners used for transport and support for
GAP cabinet(s)
General purpose
Tools and Materials
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Purpose
■ ■ ■ ■ ■ ■
■
■
Continued
1-7
JUL 2007