Configure Aga8 Parameters; Configure Continuous Flow Analysis Parameters - Emerson Daniel 3415 Operation Manual

5.10.2

Configure AGA8 parameters

Configure the properties necessary for the AGA8 calculations.
How the AGA8 calculations to be performed:
•
•
AGA8 method
•
•
•
Gas composition
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
5.10.3

Configure Continuous Flow Analysis parameters

Configure the Continuous Flow Analysis features of the Daniel Ultrasonic meter. This
Daniel MeterLink
Analysis setup was selected on the Startup Page and you have a valid Continuous Flow
Analysis key. These features require that the meter baseline be set using the Tools|Set
Baseline Wizard.
(1) If a flow computer or SCADA system is used to write these values to the meter, they do not have to be entered at this time.
Operations manual
Internally by the meter - calculates the flow mass density, the flow compressibility
and the base compressibility.
Externally - calculations are done externally. The calculated values must then be
written to the meter using Daniel MeterLink
Gross Method 1
Gross Method 2
Detail - enter the amount of each of the 21 gas components as a percentage.
Fixed - use the fixed gas composition stored in the meter for all calculations.
Live GC - use a gas composition collected by the meter from a gas chromatograph
for all calculations. This option is only available with a GC key or is enabled with the
Continuous Flow Analysis key.
Configure the Gas properties for the gas chromatograph.
Base temperature.
Base pressure.
Specific gravity.
Specific gravity reference temperature.
Specific gravity reference pressure.
Volumetric gross heating value.
Volumetric gross heating value reference temperature.
Molar density reference temperature.
Molar density reference pressure.
(1)
Flow mass density.
Flow compressibility.
Base compressibility.
™
Field Setup Wizard page is displayed only if the View Continuous Flow
™
or a flow computer.
Configurations
75