Configure Informational Parameters - Emerson Micro Motion SGM Configuration And Use Manual

Configuration and Use Manual
MMI-20020954
Alert number Alert title
A120 Curve Fit Failure (Concentration)
A132 Sensor Simulation Active
A133 EEPROM Error (Display)
A136 Incorrect Display Type

9.5 Configure informational parameters

Device Tools → Configuration → Meter Information
ProLink III
Configure → Manual Setup → Info Parameters
Field communicator
The informational parameters can be used to identify or describe your meter. They are not used in process
measurement and they are not required.
Procedure
Enter data as desired.
Parameter Description
Meter Serial
The serial number of the device. Enter the value from the device tag.
Number
Message
A message to be stored in device memory. The message can contain up to
32 characters.
Descriptor
A description of this device. The description can contain up to 16 characters.
Date
A static date (not updated by the meter). Enter the date in the form mm/dd/yyyy .
Flange Type
The sensor flange type for this device. Obtain the value from the documents shipped
with the device or from a code in the model number.
Tip
• A field communicator will not support all informational parameters. If you need to configure all of the
informational parameters, use ProLink III.
• A field communicator will allow you to configure HART Tag and HART Long Tag from this location. These
parameters are replicated from Configure → Manual Setup → HART → Communications. These
parameters are used in HART communications.
Configuration and Use Manual
Configure device options and preferences
Default severity User can reset
severity
Informational No
Informational Yes
Informational Yes
Informational Yes
March 2021
83