Balance Operating Menu; Changing Menu Code Settings - KERN 770-12 Operating Instructions Manual

3 Balance Operating Menu

In the operating menu, you can define how your balance will adapt to ambient
conditions and also how it will work to meet your special requirements. For your
convenience, the menu codes have been factory-set so that you do not have to make
any changes, as a rule. If you have special operating conditions, adjust the balance to
your requirements by setting the menu codes of your choice.
The factory-set menu codes are identified by an "*" in this instruction manual. You can
select the functions not identified by an "*" by setting the respective menu codes. You
will find these codes in the section entitled "Balance Operating Parameters". If you need
to change any of the factory settings, we recommend that you enter these changes
along with the date in the column headed by "Changes".
The corresponding code for "automatic power-on" is 8 5 4.
90
3.1

Changing Menu Code Settings

To select specific functions, you will need to set
the respective menu codes.
There are three steps to change a code:
- Accessing the menu
- Setting a code
- Confirming and storing the code
For setting menu codes three keys have special
functions:
CAL
= Increases a number by one with
each press (the numbers change in
cycles)
TARE = Confirms and stores a code setting,
exits the menu
PRINT = Moves to the next of the three
numbers of a code (1st-2nd-3rd-
1st,etc.)
Now please try changing a code to adapt your
balance to a special power-on mode.
770/GS/GJ-BA-defsi-0023