Taring; Simple Weighing (Weight Determination) - KERN 770-12 Operating Instructions Manual

The display shows the following special codes for your
information:
O displayed in the upper right corner stands for OFF
The balance was disconnected from AC power
(balance reconnected to AC power or power outage longer
than 3 seconds)
O displayed in the lower left corner means standby
The display has been turned off by the ON/OFF key. The
balance is now in the ready-to-operate mode and does not
require warm-up.
means busy
Once you have turned on the balance, that symbol will be
displayed until you press a key. During operation, this
symbol indicates that the balance processor is still busy
processing a function and will not accept another command
to perform any other functions at this time.

1.3.4 Taring

A weight can be determined accurately only from a defined
zero point. Press the TARE key to zero the weight display.
You can tare within the entire weighing range of the
balance.

1.3.5 Simple Weighing (Weight Determination)

Place your sample on the weighing pan to determine the
weight. Read off the weight indicated on the display only
after the weight unit "g" or a different unit selected appears
as the stability symbol.
770/GS/GJ-BA-defsi-0023 81