Getting Started; Installation Of The Weighing Chamber - KERN 770-12 Operating Instructions Manual

1.2

Getting started

Remove the plastic sheeting, adhesive tapes and foam material from the balance.
Important information:
Control Seals on Verified Balances Approved for Use as Legal Measuring
Instruments in the EU*:
Legal regulations require the verified balance to be sealed. This control seal consists
of an adhesive label with the name „KERN" on it. This seal will be irreparably
damaged if you attempt to remove it. In this case, the validity of the seal becomes
void and you must have your balance re-verified.
76
For model 770-60
Connecting the Balance to the Electronics Box.
- Plug the cable into the socket of the electronics box

1.2.1 Installation of the weighing chamber

For models 770
Place the components listed below inside the chamber in
the order given:
- Shield ring
- Weighing pan
For models GS/GJ with a glass draft shield
Place the shield disk on the balance. Turn the disk
-
counter-clockwise until it stops and is secured.
Place the components listed below on the balance in the
order given:
- Pan support
Weighing pan
-
- Glass draft shield cylinder
- Draft shield cover
770/GS/GJ-BA-defsi-0023