Reset Function - Undoing All Menu Code Changes - KERN 770-12 Operating Instructions Manual

The current code setting in the balance operating menu is identified by a small,
superscript "o" after the last number. When you access the operating menu, the
previously set code will be displayed after you have selected the right-hand number,
which means the entire menu code setting will be displayed. This makes it easy for you
to check the previously set menu codes.
If you would like to change several menu code settings, you do not have to press the
TARE key after each change to exit the balance operating menu. You can also confirm
individual settings.
Important Note !
By turning of the access switch an accidental alteration of the menu settings can be
avoided.
You can make this setting anytime you wish once you have accessed it. However, it is
best if you wait to lock the menu until you have changed the last code setting.
Leaving the Menu without Storing Changes to the Code Settings
Changes to the code settings are not stored if you turn off the balance by pressing the
ON/OFF key while changing the settings and before saving them.

3.1.2 Reset Function - Undoing All Menu Code Changes

The reset function enables you to undo all menu code changes, which means that you
will obtain the original factory-set menu codes identified by an "*". To use this function,
select code 9--1 .
!
See the previous page for information on confirming and storing a menu code setting.
92 770/GS/GJ-BA-defsi-0023