Electrical Connections, Protective Motor Switch And Communication Cables (Gold Cx Only); Protective Motor Switch; Communication Cables - Swegon GOLD RX Series Instructions For Installation Manual

1.13 Electrical connections, protective motor
switch and communication cables
(GOLD CX only)
The electrical connections should be wired by a qualified
electrician in accordance with local electrical safety regula-
tions.
Dismantle the Cover panels and blanking plate in front of
the electrical equipment cubicles.
Connect the cables for the protective motor switch and
the communication cables between the upper and lower
electrical equipment cubicles, see the illustration below.

1.13.1 Protective motor switch

GOLD CX 100 and 120, capacity variant 1
Cables from the lower electrical equipment cubicle (con-
nected at the factory) should be connected in the upper
electrical equipment cubicle as illustrated below. Run
the cables into the upper electrical equipment cubicle
through the grommets on the cover panel and in the
electrical equipment cubicle.
Upper electrical equipment cubicle
GOLD CX 120, capacity variant 2
Cables from the lower electrical equipment cubicle (con-
nected at the factory) should be connected in the upper
electrical equipment cubicle as illustrated below. Run the
cables into the upper electrical equipment cubicle through
the grommets on the cover panel and in the electrical
equipment cubicle.
Upper electrical equipment cubicle
26 www.swegon.com
Cover panel Blanking plate
Communica-
tion cables
Cables for
the protec-
tive motor
switch

1.13.2 Communication cables

There are 2 or 3 communication cables from the upper
electrical equipment cubicle (connected at the factory)
which should be connected in the lower electrical equip-
ment cubicle, depending on the variant selected.
Run the cables into the lower electrical equipment cubicle
through the grommets on the cover panel and in the
electrical equipment cubicle.
Control circuit card in the lower electrical equipment cubicle
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
A B GND + - + - + - + - + - + -
Com 1 Com 2 Com 3 Com 4 Com 5 SA Temp
Sensor 1 Sensor 2 Sensor 3 Sensor 4
One or two of the com-
munication cables is/are
marked Sensor 1, 2, 3 or 4
and should be connected
to the corresponding bus
contact.
Swegon reserves the right to alter specifications.
GB. GOLDINE120.130915
Upper electrical
equipment cubicle
Lower electrical
equipment cubicle
16 17 18 19 20 21 22 23 24 25 26 27 28 29
+ - + - C NO C NO C NO C NO P G
Heat Cool
SD
WLAN
CPU 2
CPU 1
Com 6 Com 7 Com 8 Com 9 Com 10 Com 11
+ - G G0 Y U 24V AC In 18V AC In 230V AC Out 230V AC In
33 34 35 36 37 38 39 40 41 42 43 44 45 46
One of the communication
cables is always marked
COM6-11 and should be
connected in an optional
bus contact marked COM6-
11.
30 31 32
G0 G G0
24V AC
47