To Connect External Cables; Gold Rx; Gold Cx - Swegon GOLD RX Series Instructions For Installation Manual

Sizes 100/120
Table of Contents

Advertisement

1.15 To Connect external cables

1.15.1 GOLD RX

To make the control unit accessible, open the inspection
door in front of the heat exchanger.
The decorative fitting can be used as a cable trough if you
need to run external cables. Dismantle the decorative fit-
tings and fold back an appropriate number of "tongues"
in the ends of the decorative fittings and run cables
through cable grommets in the decorative fitting of the
heat exchanger section. Refit the decorative fittings. Run
the cables further in to the electrical equipment cubicle
through the rubber diaphragm in front of the cubicle on
the heat exchanger section. Dismantle the service hatch to
enable you to run the cables. See illustration.
NOTE! External communication cables outside the air
handling unit should be positioned at a min. distance of
100 mm from energized cables.
Decorative fitting
Cable
Control circuit board inside the
electrical equipment cubicle
28
www.swegon.com

1.15.2 GOLD CX

To gain access to the control unit, remove the cover panel
on the lower part of the coil heat exchanger and the
blanking plate of the electrical equipment cubicle.
The decorative fitting can be used as a cable trough if you
need to run external cables. Dismantle the decorative fit-
tings and fold back an appropriate number of "tongues"
in the ends of the decorative fittings and run cables
through cable grommets in the decorative fitting of the
heat exchanger section. Refit the decorative fittings. Run
the cables further into the electrical equipment cubicle
through the rubber diaphragm in front of the electrical
equipment cubicle on the heat exchanger section. See
illustration.
N.B.! External communication cables outside the air han-
dling unit should be positioned at a min. distance of 100
mm from energized cables.
Decorative fitting
Service hatch
GB. GOLDINE120.130915
Cable
Blanking plate, electri-
cal equipment cubicle
Control circuit board inside the
electrical equipment cubicle
Swegon reserves the right to alter specifications.
Cover panel

Advertisement

Table of Contents
loading

Table of Contents