To Connect Air Tubes To Filter Pressure Sensors - Swegon GOLD RX Series Instructions For Installation Manual

1.10.6 To connect air tubes to filter pressure sensors

24 www.swegon.com
- +
GB. GOLDINE120.130915
Connect the air tube from the air nipple below the filter
to the + connection on the filter pressure sensor as
shown in the illustration. The air tubes are connected to
each air nipple (below the filter) and are rolled up inside
each fan/filter section.
The illustration shows the GOLD RX, fan arrangement 2.
The principle is however the same for other air handling
units.
Swegon reserves the right to alter specifications.