Heat, Humidity, And Dust; Power Cord Cabling; Reliable Earthing; Circuit Overloading - Pico Digital XDS-PRO SERIES User Manual

XDS-PRO Satellite Receivers

2.2.3 Heat, Humidity, and Dust

In order to avoid unnecessary internal damage, avoid placing the receiver next to external heat sources
such as heaters, direct sunlight, heating ducts, etc. Also avoid locations of high humidity, dust, and
vibration.

2.2.4 Power Cord Cabling

Avoid running the power cord across places of high traffic where it can be crimped or tripped over. Make
sure the cords are securely fastened to both the wall outlet or power strip, and the back of the receiver.
Do not place objects on or leaning against power cords.

2.2.5 Reliable Earthing

Proper mains earth grounding of the electronic rack system and rack mounted equipment should be
maintained. To ensure proper and reliable grounding of the XDS-PRO Receiver, the electronic rack system
shall employ either permanently wired mains connection or use pluggable equipment type B type wiring
in a restricted access location with proper equipotential bonding applied. The XDS-PRO Receiver includes
a rear panel grounding stud for connection to the electronic rack ground rails.
The XDS-PRO Receiver must be connected to an earthed mains socket-outlet.
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan
Apparatet må tilkoples jordet stikkontakt
Apparaten skall anslutas till jordat uttag

2.2.6 Circuit Overloading

The XDS-PRO receiver can draw up to 1.5 Amps at 120VAC as indicated on the back of the receiver.
When adding the receiver to an already existing rack setup, take care to ensure the maximum current
rating of the circuit is not exceeded.

2.2.7 Foreign Objects

If a foreign object is inserted into the receiver, immediately power down the receiver and contact Pico
Digital technical support. Do not open the receiver, as doing so will void the receiver's warranty.
2.3

Physical Installation of the Receiver

The following section will guide you through the physical installation of the XDS-PRO receiver.
9
www.picodigital.com
Make sure all rack mounted equipment and the electronic rack
system is properly grounded.
Warning!
any
Inserting
the receiver can result in shock or serious injury of the operator.
Warning!
type of foreign object into the ventilation holes of
R830001-2001, REV. C
TOLL FREE 800.421.6511