Table of Contents
Advertisement
XDS-PRO Satellite Receivers
2.5.8 Setting Up "IP Only Mode"
If it is desired to run the XDS-PRO receiver in IP Only Mode (i.e. – no RF used), it can be enabled in two
ways:
1. (for XDS-PRO receivers with a Front Panel) – Navigate to the IP Only Mode section on the Front
Panel (see Figure 1), and select "Enabled".
2. Using the TUNER command (see Section 6.2), DISABLE (all) tuners to automatically enable IP
Only mode.
Note: These are only how to get the receiver itself in IP Only Mode. It takes much more work to get the
entire system running in that mode, and is beyond the scope of this manual.
2.6
Connecting the Audio Ports
Your XDS-PRO receiver can output both analog and digital audio depending on its configuration.
Networks will generally assign stations statically to an individual port or port configurations can be
modified through the Affiliate Website.
2.6.1 Analog Audio Ports
The four ports on the back of the PRO4Q and PRO4R receivers labeled Audio A, Audio B, Audio C, and
Audio D output analog audio. For information on the pin-out of these ports, please see Section 8.1.4. For
the PRO1Q and PRO1R, the audio port labeled Audio A also outputs analog. For information on the pin-
out of these ports, see Section 8.1.4.
2.6.2 Digital Audio Port
The PRO4Q, PRO1R, and PRO4R each has a port on the back of the receiver labeled AES/EBU, which
outputs digital versions of the audio output from analog audio ports Audio A-D. Refer to Section 8.1.7 for
connector pin-out information. The PRO1Q receiver
2.7
Connecting the Relay Ports
The PRO4Q and PRO4R receivers are equipped with two RS-232 ports, labeled Relay A and Relay B, each
of which are capable of receiving cue signals from the Network signal and firing relay closures. The
PRO1Q and PRO1R receivers are equipped with one RS-232 port, labeled Relay A, with the same
capabilities.
2.7.1 Physical Ports
Each of the RS-232 ports on the back of the PRO4Q and PRO4R receiver have 32 relay closures that can
be mapped. The relay mappings can be modified, viewed and toggled through the Affiliate Website
(Section 5), toggled only through the front panel (Section 3.3.4) or viewed through the receiver website
(Section 4). For pin-out information on the RS-232 ports, see Section 8.1.2.
The RS-232 port on the back of the PRO1Q and PRO1R has 16 relay closures that can be mapped. The
relay mappings can be modified, viewed or toggled through the Affiliate Website (Section 5) or viewed
through the receiver website (Section 4). For pin-out information on the RS-232 ports please see Section
8.1.2.
2.7.2 Cues
The XDS-PRO receivers are capable of firing multiple types of relays:
Associated cues will fire when the associated program is playing. In addition, these cues will be
recorded for delayed playback.
13
www.picodigital.com
does not
provide digital audio output.
R830001-2001, REV. C
TOLL FREE
800.421.6511
Advertisement
Table of Contents
