Table of Contents
Advertisement
XDS-PRO Satellite Receivers
E0 and E1 Commands: The E0 and E1 commands change various settings for the first and second
Ethernet ports respectively. The syntax for these commands is shown in Table 2.
Option
SHOW
MAC
DHCP
ADDR
MASK
PROXY
DNS
GATEWAY
WWW
BOA
ROUTE
KEEPALIVE
FAN Command: This command is used for checking the status of and setting receiver fan speeds.
Option
SHOW
X
X
X
FIRE Command: Fire cues locally on the receiver. Syntax is: FIRE [CUE] (e.g. – "C:T01", or
"2:PGM:CODE")
HELP Command: This command prints all of the commands available to the current profile. There are
no options for this command.
42
www.picodigital.com
Argument
[ON/OFF]
[xxx.xxx.xxx.xxx]
[xxx.xxx.xxx.xxx]
[xxx.xxx.xxx.xxx]:PORT
[xxx.xxx.xxx.xxx],...
[xxx.xxx.xxx.xxx]
[xxx.xxx.xxx.xxx],
[xxx.xxx.xxx.xxx]
[port]
[secs]
Table 2 - E0 or E1 Command Parameters
Argument
AUTO
VAL
TACH
Table 3 - FAN Command
Action
Shows various technical data regarding the specified
port.
Same as the SHOW option.
Sets DHCP to ON or OFF depending on the argument.
Sets the Ethernet port's address to argument.
Sets the Ethernet port's subnet mask to the argument.
Sets the Ethernet port's proxy address and port.
Sets the Ethernet port's DNS servers. One to three DNS
addresses can be specified in a coma delimited list.
Sets the Ethernet port's gateway to the argument.
Sets the Ethernet's primary URL to the first argument,
and sets the secondary URL to the second argument.
Set internal web server port (Default = 80)
Keep-alive by ping of default gateway
Basic fan status check
Set fan x to AUTO (x=0)
Set fan x to val percent (x=0)
Get fan x tach value (x=0)
Action
TOLL FREE
R830001-2001, REV. C
800.421.6511
Advertisement
Table of Contents
