Table of Contents
Advertisement
XDS-PRO Satellite Receivers
Option
SHOW
VOL
HP
BAUD Command: Get and set Console (M&C) baud rate, parity setting, data bit, and stop bit settings.
FACTORY Command: Resets all of the receiver's settings to factory defaults. The syntax is FACTORY
DEFAULTS, [USER/FULL] where USER will reset basic settings to factory defaults and FULL will
additionally reset Ethernet and Tuner parameters. Using this command requires a receiver restart.
FIND Command: See GREP Command.
FPGA Command: FPGA diagnostics command. Syntax: FPGA LOAD [filename].
GREP Command: Unix command used to search log files. Prints output containing specific pattern.
Syntax: GREP [pattern] [cmd]
I2C Command: I2C Peripheral diagnostics. Table 8 shows all I2C arguments.
Option
DEV ADDR
VLAN
ISTREAM Command: Display and configure Istream. Table 9 shows all ISTREAM arguments.
Option
SHOW/STATS
DELAY
HOST
SAT
START
STOP
PARALLEL
47
www.picodigital.com
Argument
[Status, SN, IP, VOLUME, HP
SOURCE, FAULT]
[0-100]
[A-D]
Argument
[val]
[FLASH/ERASE]
Table 8 - I2C Command
Argument
[seconds]
[primary],[[backup|CLEAR]]
[0/1]
[slot],[pid]
[slot]
[0/1]
Action
Shows AMR settings, dependant on the
argument used.
Get / Set the AMR volume
Get / Set the AMR headphone source
Action
Action
0=default
Satellite Backup
0=Disable, 1=Enable
Turn on parallel fetch mode
R830001-2001, REV. C
TOLL FREE
800.421.6511
Advertisement
Table of Contents
