Table of Contents
Advertisement
Figure 10 VMG3925-B10C/B30C Rear Panel
The following table describes the items on the rear panel.
Rear Panel Ports
LABEL
DSL
LAN1 ~ LAN4
WAN
Power
Reset
Power
Button
1.4.6 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously and the password will be reset to the factory default (see
the device label).
Make sure the PWR/SYS LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for more than five seconds
2
or until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to blink, the
defaults have been restored and the device restarts.
Chapter 1 Introducing the VMG
DESCRIPTION
Connect a RJ-11 cable to the DSL port for Internet access.
Connect computers or other Ethernet devices to Ethernet ports for Internet
access.
Connect an Ethernet cable to the Ethernet WAN port for Internet access.
Connect the power cable and press the power button to start the VMG.
Press the button to return the VMG to the factory defaults.
Press the power button after the power cable is connected to start the
VMG.
VMG3925-B10C/B30C User's Guide
25
Advertisement
Table of Contents
