Changing The Engine Oil And Filter - Toro Groundsmaster 3280-D Operator's Manual

1. Oil-fill cap
5. Install the oil-fill cap and close the hood.
Changing the Engine Oil
and Filter
Service Interval: After the first 50 hours
Every 150 hours
Crankcase capacity: approximately 3.8 L (4 US qt)
with the filter.
1. If possible, run engine just before changing oil
to warm it.
2. Position the machine on a level surface.
3. Open the hood.
4. Align a drain pan under the oil pan and in line
with the drain plug
1. Drain plug
5. Clean the area around the drain plug.
6. Remove the drain plug and allow the oil to flow
into the drain pan.
7. Install the drain plug and wipe up any spilled oil.
8. Remove and replace the oil filter
Figure 46
(Figure 47).
Figure 47
(Figure
g001203
1. Oil filter
9. Fill the crankcase with specified oil; refer to the
Engine Oil Specification (page 43)
the Engine-Oil Level (page
g001230
48).
44
Figure 48
and
43).
g001231
Checking