Installing The Steering Wheel; Installing The Hood Handle - Toro Groundsmaster 3280-D Operator's Manual

WARNING
The machine is shipped with the power takeoff (PTO) universal shaft attached to the frame.
Do not operate the PTO without first removing the universal shaft or coupling it to a suitable
implement.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel
Parts needed for this procedure:
1 Steering wheel
1 Cover
Procedure
1. Remove the steering wheel from the shipping
skid (Figure 3).
1. Steering wheel
2. Jam nut
3. Dust cover
Figure 3
4. Foam collar
5. Cover
6. Washer
2. Remove the jam nut and washer from the
steering shaft.
Note:
Ensure that the foam collar and dust
cover remain on the steering shaft
3. Slide the steering wheel and washer onto the
steering shaft
4. Secure the steering wheel to the shaft with
the jam nut. Tighten the jam nut to 27-35 N∙m
(20-26 ft-lb).
5. Mount the cover to the steering wheel
2

Installing the Hood Handle

Parts needed for this procedure:
1 Handle
2 Screws
Procedure
1. Remove and discard the 2 screws and nuts
securing the hood cable bracket and to the
underside of the hood
g001190
1. Hood cable bracket
2. Mount the handle and the cable bracket to the
hood with 2 screws
12
(Figure
(Figure 3).
(Figure 4).
Figure 4
(Figure 5).
3).
(Figure 3).
g198431