WARNING
Incorrect battery cable routing could
damage the machine and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Connect the cables to the correct
battery post.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
1. Positive (+)
2. Negative (-)
Note:
Route the battery cables away from all
sharp edges or moving parts.
3.
Install the negative-battery cable (black) to the
negative (-) terminal of the battery
8
Checking the Fluid Levels
No Parts Required
Procedure
•
Check the engine-oil level before and after
first starting the engine; refer to
Engine-Oil Level (page
•
Check the level of the rear-axle lubricant (4-wheel
drive machines only) before first starting the
Figure 11
3. Front of the machine
(Figure
Checking the
43).
engine; refer to
(page
51).
•
Check the level of the bidirectional clutch lubricant
(4-wheel drive machines only) before first starting
the engine; refer to
Clutch Lubricant (page
•
Check the coolant level before first starting the
engine; refer to
Coolant Level (page
•
Check the level of the hydraulic fluid before first
starting the engine; refer to
System and Fluid Level (page
9
Checking the Tire Pressure
No Parts Required
Procedure
Check the tire pressure; refer to
Pressure in the Tires (page
Important:
ensure a good quality-of-cut and proper machine
performance. Do not underinflate the tires.
g033894
10
Installing the Rear Weights
11).
Parts needed for this procedure:
-
Rear weight kit(s)—as needed
Procedure
This machine alone complies with EN ISO 5395:2013
and ANSI B71.4-2017 standard when equipped with
factory installed rear weight—98 kg (215 lb) on Model
30344 (2WD machines) and 23 kg (50 lb) on Model
30345 (4WD machines). When you equip the machine
with the listed attachments, use Table 1 to determine
the additional weight required to maintain standards
compliance. Order parts from your authorized Toro
distributor.
Note:
Before installing any third-party kits, contact
your authorized Toro distributor.
16
Checking the Rear Axle Lubricant
Checking the Bidirectional
52).
Checking the Cooling System and
57).
Checking the Hydraulic
64).
Checking the Air
26).
Maintain pressure in all tires to