After Operation
After Operation Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or transporting the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Keep all parts of the machine in good working
condition and all hardware tightened, especially
blade-attachment hardware.
•
Maintain and clean the seat belt(s) as necessary
•
Replace all worn or damaged decals.
Pushing or Towing the
Machine
In an emergency, you can move the machine a very
short distance by actuating the bypass valve in the
hydraulic pump and pushing or towing the machine.
Important:
Do not push or tow the machine
faster than 3 to 4.8 km/h (2 to 3 mph). If you push
or tow at a faster speed, internal transmission
damage may occur. If you must move the machine
a considerable distance, transport it on a truck
or trailer.
Important:
The bypass valve must be open
whenever you push or tow the machine. Close
the valve once you have pushed or towed the
machine to the desired location.
Opening the Bypass Valve
1.
Remove the seat and seat plate; refer to
Removing the Seat and Seat Plate (page
2.
Locate the control knob for the bypass valve at
the left side of the hydraulic pump
1. Hydraulic pump
2. Control knob (bypass
valve)
3.
4.
Closing the Bypass Valve
Note:
1.
2.
3.
4.
39).
(Figure
29).
33
Figure 29
Rotate the control knob 3 turns counterclockwise
(Figure
29).
Important:
Do not rotate the control knob
more that 3 turns.
Push or tow the machine.
Close the bypass before you start the engine.
Finish pushing or towing the machine.
Locate the control knob for the bypass valve at
the left side of the hydraulic pump
Rotate the control knob
until you feel resistance, indicating that the
bypass valve is closed.
Install the seat and seat plate; refer to
the Seat and Seat Plate (page
g034181
3. Front of the machine
(Figure
29).
(Figure
29) clockwise
Installing
39).