Adjusting The Traction Pedal - Toro Groundsmaster 3280-D Operator's Manual

Adjusting the Traction
Pedal
Adjusting the Traction-Pedal Stop
You can adjust the traction pedal for operator comfort
or to reduce the maximum forward speed of the
machine.
1. Move the traction pedal fully forward
Note:
The traction pedal should contact the
traction-pedal stop before the pump reaches
full stroke.
Figure 75
1. Traction pedal
2. Traction-pedal stop
2. If the traction pedal does not contact the
traction-pedal stop or if you want to reduce
the forward speed of the machine, perform the
following:
A. Hold the traction-pedal stop
a wrench.
B. Loosen the jam nut at the bottom of the
footrest plate
(Figure
3. Jam nut (top of the footrest
plate)
(Figure 75) with
(Figure 76).
75).
1. Front of the machine
C. Move the traction pedal to the full forward
position
D. While holding the traction-pedal stop, adjust
the jam nut that is above the footrest plate
(Figure
contact with the stop.
E. Lengthen the traction-pedal stop position
by rotating the stop 1 full rotation
counterclockwise away from the jam nut
above the footrest plate.
Note:
position will increase the forward speed of
the machine.
F. While holding the traction-pedal stop, torque
the jam nut at the bottom of the footrest
g034172
plate
N∙m (27 to 33 ft-lb).
G. Check that the traction pedal contacts
the traction-pedal stop before the pump
reaches full stroke.
Note:
the traction-pedal stop, repeat steps
through
Rod (page
62
Figure 76
2. Jam nut (bottom of the
footrest plate)
(Figure 75).
75) until the traction pedal makes
Shortening the traction-pedal-stop
(Figure 75 and Figure
If the traction pedal does not contact
G or refer to Adjusting the Traction
63).
g035119
76) to 37 to 45
A