Adjusting The Roll Bar; Activating And Charging The Battery - Toro Groundsmaster 3280-D Operator's Manual

Note:
Discard the 2 mounting bolts and flat
washers.
2. Remove the 2 nuts and vinyl caps (if previously
installed) securing the upper seat bracket to the
left side of the seat suspension
3. Loosely mount the R-clamps to the seat bracket
studs with the 2 nuts previously removed
7).
Note:
Position the R-clamps under the
seat-suspension tabs.
1. R-clamps
2. Upper seat bracket
3. Seat suspension
4. Install the manual tube into the R-clamps and
tighten the nuts (Figure
5. Insert the vinyl caps onto the seat bracket studs.
6

Adjusting the Roll Bar

No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the
2 pins from the roll bar
(Figure 7).
Figure 7
4. Manual tube
5. Vinyl cap
7).
(Figure 8).
(Figure
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and
install the 2 pins and secure them with the
hairpin cotters
Note:
Keep the roll bar in the raised and locked
position. Lower the roll bar temporarily only
when absolutely necessary.
Important:
the roll bar is in the down position.
g001888
7
Activating and Charging
the Battery
No Parts Required
Adding Electrolyte to the Battery
WARNING
Battery electrolyte contains sulfuric acid,
which is lethal if consumed and causes
severe burns.
• Do not drink electrolyte and avoid contact
with skin, eyes, or clothing. Wear eye
protection to shield your eyes and rubber
gloves to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
Important:
gravity of 1.265 to initially fill battery.
1. Remove the battery from the machine.
14
Figure 8
3. Hairpin cotter
(Figure 8).
The roll bar is an effective safety device.
Do not wear the seat belt when
Use only electrolyte with a specific
g001199