Toro Groundsmaster 3280-D Operator's Manual page 65

6. Thread the dipstick fill cap onto the filler tube.
Note:
Do not tighten the cap with a wrench.
7. Check all hoses and fittings for leaks.
Changing the Hydraulic Fluid and
Filter
Service Interval: After the first 10 hours—Change the
hydraulic-fluid filter. Do not exceed
10 hours or you will damage the
hydraulic system.
Every 200 hours—Change the hydraulic-fluid
filter.
Every 1,500 hours—Replace the hydraulic fluid.
Hydraulic fluid capacity: approximately 5.6 L (6 US
qt)
1. Lower the deck to the shop floor, shut off the
engine, and remove the key from the key switch.
2. Block the 2 rear wheels.
3. Jack up both sides of the front axle and support
it with jack stands.
4. Replace the hydraulic filter
Note:
Drain pan capacity: a 5.6 L (6 US qt)
capacity or greater.
Figure 80
(Figure 81).
g034079
5. Remove jack stands and lower the machine.
6. Add the specified hydraulic fluid into the fill tube
(Figure 80) until the fluid level in the transaxle
housing (reservoir) shows at the midpoint
between the upper and lower marks of the
dipstick (Figure 79
Important:
with hydraulic fluid above the upper mark of
the dipstick.
7. Start the engine, cycle the steering wheel and
deck-lift cylinders, and check for oil leaks. Allow
the engine to run for about 5 minutes, then shut
it off.
8. After 2 minutes, check the level of the hydraulic
fluid; refer to
and Fluid Level (page
65
Figure 81
).
Do not fill the transaxle housing
Checking the Hydraulic System
64).
g034076