Torquing The Bolts For The Steering-Cylinder Mount; Adjusting The Traction Drive - Toro Groundsmaster 3280-D Operator's Manual

5. After attaining the desired wheel alignment,
assemble ball joint to the mounting bracket with
the castle nut and cotter pin.
6. Tighten the locknut and bolt at the tie-rod clamp.
Torquing the Bolts for the
Steering-Cylinder Mount
4-Wheel Drive Machines Only
Service Interval: Every 200 hours
1. Move the machine to a level surface, shut off the
engine and remove the key from the key switch.
2. Torque the 4 bolts for the steering-cylinder
mount (Figure
1. Bolt—4 each (steering-cylinder-mount)
Adjusting the Traction
Drive
If the machine moves when the traction pedal is in the
neutral position, adjust the traction cam.
Preparing to Adjust the Traction
Drive
Lifting equipment and jack stand capacity: 1900
kg (2 ton) or greater
1. Move the machine to a level surface, shut off the
engine, and engage the parking brake.
WARNING
If the machine is not supported
adequately, it may accidentally fall,
injuring anyone under the machine.
Raise all 4 wheels off the ground or the
machine may move while adjusting the
traction drive for neutral.
2. Raise the machine and support it with 4 jack
stands of the specified capacity under the frame.
3. Remove the seat and seat plate; refer to
Removing the Seat and Seat Plate (page
54
64) to 65 to 81 N∙m (48 to 60 ft-lb).
Figure 64
g003496
39).