Cisco IE-4000 Software Configuration Manual page 529

Configuring System Message Logging
Additional References
000019: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Enabling the Logger: Example
This example shows how to enable the configuration-change logger and to set the number of entries in the log to 500.
Switch(config)# archive
Switch(config-archive)# log config
Switch(config-archive-log-cfg)# logging enable
Switch(config-archive-log-cfg)# logging size 500
Switch(config-archive-log-cfg)# end
Configuration Log Output: Example
This is an example of output for the configuration log:
Switch# show archive log config all
idx sess
38 11 unknown user@vty3
39 12 unknown user@vty3
40 12 unknown user@vty3
41 13 unknown user@vty3
42 14
43 14
44 14
45 16
46 16
47 16
Additional References
The following sections provide references related to switch administration:
user@line Logged command
|no aaa authorization config-commands
|no aaa authorization network default group radius
|no aaa accounting dot1x default start-stop group radius
|no aaa accounting system default
temi@vty4 |interface GigabitEthernet4/0/1
temi@vty4 | switchport mode trunk
temi@vty4 | exit
temi@vty5 |interface FastEthernet5/0/1
temi@vty5 | switchport mode trunk
temi@vty5 | exit
525