Analogue Actuator Module Aam/S - ABB i-bus EIB/KNX AA/S 4.1 Product Manual

ABB i-bus EIB / KNX
®
5.1.2 Analogue Actuator Module
AAM/S 4.1
20
Planning and application
Status LED device (red)
On
flashes quickly
flashes slowly
Off
On
Off
1) Flashes slowly = 1/s
2) Flashes quickly = 2/s
Status LED Output A5...A8 (yellow)
On
Off
LED display during commissioning
Module is operational (self test ok)
2) Module is currently being initialised
1) Module is not programmed
(in Analogue Actuator)
Module is initialised and put into operation.
Precondition: The LED must have switched
off beforehand!
LED display in normal operation
Module is not ready for operation (fault)
Module is initialised and programmed.
Precondition: The LED must have switched
off beforehand!
Status
Output signal is higher than zero
Output signal is equal to zero