Table of Contents
Advertisement
ABB i-bus
EIB / KNX
®
14
Commissioning
Cyclical monitoring
Options:
– no monitoring
– Input value
– Forced control
– Input value or forced control
The output can monitor the object "Input value" and / or the objects
"Forced control" on a time basis.
If an input telegram is not received in the time defined in the connection,
the output evaluates this as a fault. In this case the object "Alarm output ..."
can send a telegram with the value 1, and the output assumes the
value which is set with the parameter "Output value after exceeding of the
monitoring time in %".
Time factor for cyclical monitoring
Options:
1...255 (6)
This parameter determines the monitoring time of the output together with
the fixed time basis (basis = 10 s).
Output value after exceeding of the monitoring time in %
Options:
0...100 (0)
The output assumes the value parameterised here when the monitoring
time is exceeded.
Time between 2 of 255 dimming steps
Basis
Options:
– 10 ms
– 100 ms
– 1 s
With this parameter the basis for the dimming speed which the output
uses is determined in 8-bit mode, if it is controlled via the 4-bit object, or if
the parameter "Response on reception of value" is set to the "dimming
approach" and the output has received a new input value.
Time between 2 of 255 dimming steps
Factor (1...255)
Options:
– 1...255 (2)
With this parameter the factor for the dimming speed which the output uses
is determined in 8-bit mode, if it is controlled via the 4-bit object, or if the
following parameter is set to the "dimming approach" and the output has
received a new input value.
Response on reception of value
Options:
– direct approach
– dimming approach
In dimming actuator mode the output can rapidly assume new 1-byte
values or assume them via a dimming speed.
Advertisement
Table of Contents
