User Guide
MMI-20019808
2
Installation
2.1
Components
Ensure that you have all required components:
•
Micro Motion EtherNet/IP Module
•
Power connector
•
Micro Motion EtherNet/IP Resource CD
—
—
—
•
Configuration cable
•
Modbus serial cable and connector (included)
•
Ethernet cable and connector (not included)
2.2
Set up the module with MVD Direct Connect
Use this procedure only if you are installing the module with MVD Direct Connect.
Procedure
1. Mount and wire the core processor and barrier.
2. Power up the core processor and barrier.
3. Set the Modbus address on the core processor to 1.
Postrequisites
Continue to
User Guide
Micro Motion EtherNet/IP Module User Manual
EDS file
MicroMotion Ethernet Config Tool
Figure 2-1: Barrier
A. I.S. terminals for connection to core processor
B. Non-I.S. terminals for connection to remote host and power supply
Mount, wire, and set the network
settings.
Installation
January 2019
9