Using Weekly Timers (@); Settings In The Ladder Program Edit Screen; Settings In The Parameter Settings Screen - Omron ZEN Operation Manual

Using Weekly Timers (@)

3-8

Using Weekly Timers (@)

Operation
Stop time
Start time
Weekly timer
bit
3-8-1

Settings in the Ladder Program Edit Screen

Note
3-8-2

Settings in the Parameter Settings Screen

Note
72
Weekly timers turn ON between the specified start and stop times on
the specified days. Weekly timers have 16 points (@0 to @f.)
Mon Tues
24:00
17:30
8:15
0:00
In this example, the weekly timer turns ON every day
from Tuesday to Friday between 8:15 and 17:30.
Weekly timer inputs are written in the Ladder Program Edit Screen.
Settings are made in the Parameter Settings Screen.
Weekly timer address
Time up output
Weekly timer addresses
Only @0 to @7 (8 points) are supported by pre-V1 CPU Units.
Weekly timer address
Start day
Stop day
When the flashing cursor is on the start day, press the Right But-
ton and then the Up/Down Buttons to set the stop day. If the stop
day is not set, the timer will operate according to the set time only.
Day Start day
Stop day
Day of the week
Wed Thurs
@0 to @f (16 timers)
Monitor enabled/disabled
Start time
Stop time
Sun/Mon/Tues/Wed/Thurs/Fri/Sat
Sun/Mon/Tues/Wed/Thurs/Fri/Sat/None
Section 3-8
Fri Sat Sun