Omron ZEN Operation Manual page 83

Creating Ladder Programs
3-3-3-4 Writing a Parallel Input for Q0
3-3-3-5 Drawing Connection Lines for OR Circuits
Drawing Connection Lines
60
tons to select additional functions or select
the bit address.
Press the OK Button twice to complete writ-
ing output Q0. The highlighted cursor will
move to the input at the beginning of the next
line.
Press the OK Button to display input I0 and
move the flashing cursor to the bit type I
position.
Press the Up Button to select Q (a CPU Unit
output bit).
Press the OK Button twice to complete writ-
ing the parallel input for Q0. The highlighted
cursor will move to the next input.
Horizontal connection lines
Vertical connection lines
Intersecting lines
Press the ALT Button when the highlighted
cursor is at the input write position to change
the cursor to a left flashing arrow and enable
connection lines to be drawn. Move the left
arrow the position for drawing the connection
line and press the Up, Down, Left, and
Right Buttons to draw connection lines verti-
cally and horizontally.
It will not be possible to draw connection
lines when the beginning or end of the line
has been reached or if the OK and ESC But-
tons are pressed.
Press the ALT Button to enable drawing con-
nection lines.
Section 3-3