Omron ZEN Operation Manual page 123

Connecting the ZEN Support Software
Setting Node Addresses
When a ZEN Support Software is connected, the node address set on the
ZEN Support Software must match the node address set on the CPU
Unit. Communications cannot be performed if the node addresses do not
match. Use the following procedure to set the node addresses.
Select Other/
Node No.
/
Note
100
768FGDBCU
DIQVUÃADGU@S
HP9@HÃDID
IP9@ÃIP
IP9@ÃIP


The ZEN must be connected 1:1 to the computer, i.e., only one
ZEN can be connected to the computer at the same time.
Press the OK Button to display the current
settings.
Press the OK Button again to enable the
node address to be set.
Use the Up/Down and Right/Left Buttons to
set the node address between 0 and 9.
Press the OK Button to confirm the setting.
Press the OK Button again to complete the
setting.
Section 5-3