Amada HFA-250 Operator's Manual page 57

[22] HEAD-END POSITIONING button (option)
Starts the head-end positioning of the work. Pressed to flash the built-
in light and raise the sawhead to the upper limit. When the head-end
positioning of the work is completed, the built-in light goes out.
[23] Cutting data setting controls
◯
Current station light
1
Illuminated to indicate that
the number of the station
currently being run agrees
with the number displayed
in the ST. field.
Usually, the machine starts
its automatic operation
from the station number
displayed in the ST. field,
and both cutting data
display and operation go to
the next station each time a
station is finished. The
current station light
remains illuminated during
the automatic operation.
The current station light
goes out if the ST. field is
changed to another station
number after the start of
the automatic operation.
NOTE
If the current station light is extinguished, there is no knowing which station is
currently run. Change the ST. field from one station number to another with
the ST or key until the current station light is illuminated.
The machine allows the ST. field to be changed from one station number to
another, and then the cutting data of other than current stations to be
confirmed or changed. The cutting data of the current station cannot be
changed.
◯
ST. field
2
Indicates the number for the station. The stations 1 to 99 can be used
for cutting in the AUTO mode. A maximum of 9999 pieces of the same
cutoff length can be set at each station. The station 0 is used for the
semiautomatic positioning function.
◯
L field
3
Indicates the cutoff length in the AUTO mode. The setup range is 5.0
to 9999.9 mm {0.197 to 99.999 in.}.
1 2 3 4
8
11
A C
12
9
F1 F2
13
ST ST CLR
15
17
14
5 6 7
10
F3 F4
MENU
16
18
20
19
III-7