Using Multi-Vises (Optional - Amada HFA-250 Operator's Manual

Using multi-vises (optional)

FRONT VISE
IV-24
Use the multi-vises as described below.
NOTE
When stack cutting workpieces, check that they are each securely clamped,
and take special care so that they do not vibrate. Vibration adversely affects
the life of the saw blade.
1 Open the front and rear vises wider than the nest width of
workpieces, and stack the workpieces on the front and rear vise
tables.
2 Install the multi-vises
on the front and rear
vises. They need
not be fixed at this
point of time.
3 Connect the hydraulic hoses of the multi-vises to the plugs of the
front and rear vise cylinders.
4 Install the stack
cutting fence on the
work tray.
The stack cutting
fence is designed to
prevent the stack-cut
pieces from collapsing
on the work tray.
Securely fix the stack
cutting fence to a
width slightly greater
than the width of the
nest.
4-)4 815-
STACK
CUTTING
FENCE