Alarm Code List - Amada HFA-250 Operator's Manual

ALARM CODE LIST

Alarm code
E-000 Control system is faulty.
E-001 Saw blade is broken.
If saw blade is not broken,
saw blade breakage detection
limit switch is faulty.
E-002 BLADE DRIVE button was
(option) pressed with wheel cover
opened.
Wheel cover was opened
while saw blade was running.
If wheel cover is not open,
wheel cover open limit switch
is faulty.
E-003 Sawhead upper and lower
limit detection limit switches
simultaneously turned on.
Sawhead upper and lower
limit detection limit switches
are faulty.
E-004 During automatic operation,
work did not come within ±0.2
mm {±0.008 in.} of target
position after three positioning
attempts.
E-005 During automatic operation,
work became too short to be
clamped with rear vise.
Stacked workpieces
collapsed during stack
cutting.
Either front or rear vise
pressure switch is faulty.
V-6
To clear an alarm, press the CLR key of the cutting data setting controls.
If the alarm cannot be cleared, contact AMADA.
Cause Remedy
Turn off power and then turn it
back on. (If alarm recurs,
contact AMADA.)
Turn saw blade tension lever
to " ", and press and
hold HYDRAULIC ON button
for 5 to 10 seconds until saw
blade breakage limit switch is
turned off. Then clear alarm.
Contact AMADA.
Close wheel cover, and clear
alarm.
Contact AMADA.
Clear alarm.
Contact AMADA.
Contact AMADA.
Clear alarm, and change
work.
Clear alarm, and restack
workpieces.
Contact AMADA.
Remarks
Hydraulic pump
motor stops.
Hydraulic pump
motor stops.
Saw blade stops
running.
Hydraulic pump
motor stops.
Saw blade stops
running.
Hydraulic pump
motor stops.