Connecting Power Cable - Amada HFA-250 Operator's Manual

Connecting power cable

Connect the power cable to the machine as described below.
1 Turn off the shop
circuit breaker switch.
2 Open the door of the
electrical enclosure.
3 Pull the power cable
from the shop circuit
breaker through the
power inlet into the
electrical enclosure.
4 Connect the three
power cable
conductors to the L1
(R), L2 (S) and L3 (T)
terminals of the
machine circuit
breaker.
5 Connect the
grounding conductor
to the ground terminal
on the left side of the
machine circuit
breaker mounting
bracket (deep in the
electrical enclosure).
6 Check that the circuit protectors QF2, QF3 and QF4 are turned on.
7 Close the door of the electrical enclosure.
POWER INLET
GROUND TERMINAL
L1 (R), L2 (S), L3 (T)
TERMINALS
II-11