Positioning Remnant For Cutting Further - Amada HFA-250 Operator's Manual

POSITIONING REMNANT FOR CUTTING FURTHER

12 Press and hold the
REAR VISE
FORWARD button to
move the rear vise to
the forward limit.
If the work becomes too short, it cannot be clamped when the rear vise
is moved backward. This condition actuates the work absence
detection function and does not allow the automatic operation of the
machine.
The smallest possible length of this remnant is 76 mm {3 in.} when the
grip allowance of the rear vise is 10 mm {0.4 in.}. When cutting the
remnant further, position it as described below.
1 Remove the remnant
from the rear vise
table.
2 Press and hold the
FRONT VISE OPEN
button to open the
front vise.
3 Place the remnant on
the front vise table.
4 Move or turn around the remnant by hand to align its cutting line
with the saw blade running line.
5 Press and hold the
FRONT VISE CLOSE
button to clamp the
remnant with the front
vise.
6 Press and hold the
REAR VISE
FORWARD button to
move the rear vise to
the forward limit.
SAW BLADE
RUNNING LINE
FORWARD
LIMIT
CUTTING
LINE
IV-17