Amada HFA-250 Operator's Manual page 56

III-6
[15] REAR VISE BACKWARD button
Pressed and held to move the rear vise backward. The rear vise
cannot be moved backward if the front vise and rear vise are both
closed. The rear vise may not be moved backward when the quick
approach feeler is in contact with the work.
NOTE
The button is enabled only when the AUTO/MANUAL switch is turned to
MANUAL.
[16] REAR VISE FORWARD button
Pressed and held to move the rear vise forward. The rear vise cannot
be moved forward if the front vise and rear vise are both closed. The
rear vise cannot also be moved forward if the quick approach feeler is in
contact with the work or is raised and locked.
NOTE
The button is enabled only when the AUTO/MANUAL switch is turned to
MANUAL.
[17] REAR VISE FORWARD LIMIT light
Illuminated to indicate that the rear vise is at the forward limit.
[18] REAR VISE POSITIONED light
Illuminated to indicate that the rear vise is completely positioned.
[19] REAR VISE SLOW button
Used to select the rear vise speed. Pressed to illuminate the built-in
light and select a low speed for the forward and backward movements of
the rear vise. Pressed again to extinguish the built-in light and select a
high speed for the forward and backward movements of the rear vise.
[20] WORK LIGHT button
Used to turn on and off the work light. Pressed to illuminate the work
light and pressed again to extinguish the work light.
[21] CUTTING FLUID button
Used to start the cutting fluid pump alone for cleaning the machine.
Pressed to illuminate the built-in light and discharge the cutting fluid
even when the saw blade does not run. Pull out the cleaning nozzle in
the wire brush area, and wash away the chips on the cutting fluid pan.
Pressed again to extinguish the built-in light and stop the cutting fluid.