Contents Of Displays; Initial Display; Station Data Setup Display - Amada HFA-250 Operator's Manual

Contents of displays

INITIAL DISPLAY

STATION DATA SETUP DISPLAY

The initial display is shown
on the LCD screen for
about 7 seconds after the
power of the machine is
turned on. The LCD
screen then changes to the

station data setup display.

The contents of the item fields and the functions of the function keys
shown on the station data setup display are described below.
Displayed contents of item fields
◯
Current station light
1
Illuminated to indicate that
the number of the station
currently being run agrees
with the number displayed
in the ST. field.
Usually, the machine starts
its automatic operation
from the station number
displayed in the ST. field,
and both cutting data display and operation go to the next station each
time a station is finished. The current station light remains illuminated
during the automatic operation.
The current station light goes out if the ST. field is changed to another
station number after the start of the automatic operation.
NOTE
If the current station light is extinguished, there is no knowing which station is
currently run. Change the ST. field from one station number to another with
the ST or key until the current station light is illuminated.
The machine allows the ST. field to be changed from one station number to
another, and then the cutting data of other than current stations to be
confirmed or changed. The cutting data of the current station cannot be
changed.
1 2 3 4
8 9
5 6 7
10 11
III-19