Amada HFA-250 Operator's Manual page 104

IV-26
8 Press the MENU key
several times to
indicate in the
function label fields
the menu shown right.
9 Press the F3 (set) key
to open the setup
display as shown
right. Set the
standby position of
the rear vise on the
display.
10 Press the F2 (forward limit standby) key.
The rear vise is set to stand by at the forward limit during automatic
operation and to clamp the workpieces at the forward limit until
each cut is completed.
NOTE
If the workpieces can be securely clamped with the front vise alone so
that they do not whip up or fly off, the rear vise may be set to stand by at
the backward limit to shorten the idle time.
11 After the workpieces are completely positioned for cutting, their
stack cutting can be started in the MANUAL or AUTO mode in the
same way as during normal cutting.