Amada HFA-250 Operator's Manual page 31

Tank capacity
Pump type
Hydraulic
Pump capacity
Pressure setting
Up
Rise height setting
Saw blade control
Down
Depth-of-cut control
Slip detection
Type (capacity)
Work feed
Remnant length
[for clamp clearance of 10
mm {0.4 in.}]
Chip disposal
Table height
Saw blade twist angle
Allowable loading mass on machine
Machine dimensions (W × D × H)
Machine mass
**When the machine is equipped with an optional head-end positioning function, the remnant
must be 150 mm {5.91 in.} or longer when work with a diameter or height of less than 12 mm
{0.47 in.} is to be fed.
40 liters {10.6 US gal}
Variable-volume piston pump
22 liters/min {5.8 US gal/min}
3.5 MPa {35 kgf/cm
Hydraulic automatic rise
Automatic
(automatic stop at upper limit)
Manual Inching up by pushbutton operation
Automatic setting with quick approach feeler
Automatic Rapid approach with quick approach feeler
Manual Inching down by pushbutton operation
Hydraulic pressure-flow control valve
Automatic stop at overload, jamming, or
breakage
Hydraulic shuttle type, maximum stroke length
of 400 mm {15.75 in.}, standby position
selectable
Single cutting: 76 mm {2.99 in.}**
Stack cutting: 214 mm {8.43 in.}
Chip conveyor
(automatic hydraulic screw type)
800 mm {31.5 in.}
60°
2500 kg {5510 lb}
2472 × 2646 × 2522 mm
{97.3 × 104.2 × 99.3 in.}
Approx. 2200 kg {4850 lb}
2
or 498 psi}
I-11