Projection Mode - RGBlink FLEX RS1 User Manual

3.2.7.3 Projection Mode

Click the "Projection Mode", and enter the interface as follows:
1.Disp Area: Display area, where users can select the display layer, set the position in
blank bar after X and Y.
2.Finder Frame:where users can choose the display content here. When one display area
is selected, its corresponding finder frame is selected as well. Users set finder frame
position in the blank bar after X and Y, set size after W and H.
3.Fuse Width above Finder Frame: To adjust border blending of each projection display by
dragging the corresponding finder frame. The Fuse Width can show the exact parameter
automatically. Users can also put in the exact pixels in the blank bar after Left, Right, Top,
Bottom.
Note:Finder Frame 1 allow users to key in exact pixels of right and bottom
Finder Frame 2 allow users to key in exact pixels of left and bottom
Finder Frame 3 allow users to key in exact pixels of right and top
Finder Frame 4 allow users to key in exact pixels of left and top
Projection mode is applied to adjust the border blending of each projection output display
to make perfect splicing .
FLEX RS1 User Manual
37