Modifying Atm Vcs - SMC Networks ADSL Barricade SMC7204BRA User Manual

Configuring the ATM Virtual Circuit
6. When the [Confirmation] page appears, click [Close] to return
to the [ATM VC Configuration] page.The new interface should
now display in the [ATM VC Configuration] table.
You may need to create a new WAN interface, or modify
an existing interface, so that it uses the new VC. See the
instructions for Configuring a PPP, EoA, or IPoA interfaces,
depending on the type you use to communicate with your ISP.
You can verify that the new settings work by attempting to
access the Internet from a LAN computer. Contact your ISP
for troubleshooting assistance.
7. When you have verified that the new settings work properly,
click the [Admin] tab, and then click [Commit & Reboot] in the
task bar.
8. Click [Commit] to save your changes to the permanent
memory.

Modifying ATM VCs

Your device may already be preconfigured with the necessary
ATM VC properties, or the table may contain placeholder values
that you must change before using the device. Contact your ISP
to determine your ATM VC values. Follow these instructions to
modify a preconfigured VC:
1. From the [ATM VC Configuration] page, click
[Action(s)] column for the interface you want to modify.
The [ATM VC Interface - Modify] page appears, as shown
in Figure 35.
102
in the