Load Capacity Charts - Xtreme Manufacturing XRM945 Operation & Safety Manual

Operation
 Warning
The reach forklift includes a Frame Sway
Override switch. Improper use of the
Frame Sway Override switch can cause
property damage, injury, or death.
The frame sway feature becomes locked and will not
operate when the boom is raised 40° or more. Pressing
the Frame Sway Override switch (the red button on the
Attachment Tilt and Frame Sway Control handle OR the
foot switch) will override the lockout feature and allow
frame sway.
Figure 7-41. Frame Sway Override Switch.
Figure 7-42. Frame Sway Override Foot Switch.
Page 66

Load Capacity Charts

 Warning
DO NOT exceed rated capacities. Any
attempt to lift or carry loads in excess of
those shown on the load capacity charts
may cause forklift tip over, loss of load,
or structural damage which could result in injury
or death.
All load ratings shown on load capacity charts are
based on the forklift being on firm, level ground,
the forks being evenly positioned on the carriage,
the load being centered on the forks, properly sized
tires properly inflated, and the forklift being in good
operating condition.
Load capacity charts, located on the left side of the dash
panel, are provided to assist the operator in determining
how to safely operate the boom to pick up, carry, and set
down a load with the reach forklift, including what angle,
how high, and how far to extend the boom.
Figure 7-43. Typical Load Capacity Chart.
XRM945
Xtreme Manufacturing, LLC