Before Starting Forklift - Xtreme Manufacturing XRM945 Operation & Safety Manual

XRM945

Before Starting Forklift

 Warning
Failure to use proper safety procedures
when mounting and dismounting the
forklift could result in injury or death.
• Keep steps clear of dirt, mud, snow, ice, debris, and
other hazards.
• Face the forklift for mounting or dismounting. Use
handholds and steps to maintain three (3) points of
contact at all times, either both hands and one foot
or both feet and one hand.
• DO NOT use the controls, steering wheel, or foot
pedals as handholds or steps. Avoid accidentally
engaging or disengaging a control.
DO NOT jump from the forklift.
Clothing can get caught on pedals, levers,
or other protruding parts. Landing on
uneven surfaces can result in serious
personal injury.
1. Use safe mounting/dismounting procedures to enter
the operator cab.
2. Adjust the operator seat for position and comfort.
(Refer to Seat Adjustment section in this manual.)
3. Fasten seat belt.
4. Adjust mirrors (this may require assistance.)
5. Adjust the operator control panel.
6. Make sure the travel select lever is set to NEUTRAL (N)
and the Parking Brake is ON (engaged).
7. Master battery disconnect on.
For information call (800) 497-1704
NOTE: The engine will only start when the travel select
lever is in NEUTRAL (N) and the Parking Brake switch is ON
(engaged).
Figure 7-7. Travel Select Lever Must Be In NEUTRAL (N) To Start The
Reach Forklift.
Figure 7-8. Parking Brake Switch (A) Must Be ON (Engaged) To Start
The Reach Forklift.
Operation
Page 49