Rear View Mirrors - Xtreme Manufacturing XRM945 Operation & Safety Manual

XRM945
 Warning
DO NOT adjust the seat or seat belt while
the forklift is moving. Keep both hands on
the wheel while the forklift is moving to
prevent loss of forklift control which could
result in injury or death.
Before starting the engine, adjust the seat for position and
comfort (refer to the Operator Seat section of this manual)
and then adjust the seat belt as follows:
1. Grasp the free end of the seat belt (located on the left
side of the seat) and make sure the belt webbing is
not twisted or entangled in any portion of the seat
assembly.
2. Pull the retractable seat belt across your lap. Position
the seat belt as low on your body as possible.
3. Insert the latch plate into the buckle (on the right side
of the seat) until a "click" is heard.
4. Make sure seat belt retracts snugly across your lap.
NOTE: Depress the red push button on the buckle to
release the two inch (2") seat belt. Pull the clasp on the
buckle to release the three inch (3") seat belt.
Figure 6-14. Seat Belt.
1. Push Button Release. 2. Pull Clasp Release.
For information call (800) 497-1704

Rear View Mirrors

Two (2) adjustable rear view mirrors are provided to aid
the operator's rear vision. One (1) rectangular mirror is
mounted on the upper left of the operator's cab.
Figure 6-15. Cab-Mounted Mirror.
One (1) rear view mirror is mounted on the frame.
Figure 6-16. Frame Mounted Mirror.
Operator Cab
Page 33