Table of Contents
Advertisement
Operator Cab
Height Adjustment Knob
The seat controls include a three-step height adjustment
knob. Rotate the height adjustment knob clockwise to
raise the seat and counterclockwise to lower the seat.
NOTE: A height adjustment indicator shows which height
step the seat is adjusted to.
Figure 6-10. Height Adjustment Knob and Indicator.
Fore and Aft Adjustment Lever
Pull the fore and aft adjustment lever outward from the
seat to release the seat lock. Slide the seat forward or
backward to a comfortable location and release the lever
to lock the seat in the desired position.
Figure 6-11. Fore and Aft Adjustment Lever.
Page 32
Backrest Angle Adjustment Lever
Pull the backrest angle adjustment lever up to release the
seat backrest lock. Adjust the angel of the backrest and
release the lever to lock the backrest to the desired angle.
Figure 6-12. Backrest Angle Adjustment Lever.
Seat Belt
Warning
Always check the condition of the seat belt
and mounting hardware before operating
the forklift. If the seat belt or mounting
hardware is defective, it may not properly
restrain the operator, resulting in injury or death.
• DO NOT operate the forklift until the seat belt or
mounting hardware is replaced, if worn or damaged.
• The seat belt MUST be worn while operating the
forklift. Failure to wear the seat belt could result in
injury or death.
The reach forklift is equipped with a standard two inch
(2") wide retractable seat belt. A three inch (3") wide
retractable seat belt is optional, except when required by
federal, state, and local laws and regulations.
Figure 6-13. Retractable Seat Belt.
XRM945
Xtreme Manufacturing, LLC
Advertisement
Table of Contents
