Seat Belt; Rear View Mirrors - Xtreme Manufacturing XR1147 Operation And Safety Manual

Operator Cab

Seat Belt

Always check the condition of the seat belt
and mounting hardware before operating
the Telehandler. If the seat belt or mounting
hardware is defective, it may not properly
restrain the operator, which could result in
death or serious injury.
• DO NOT operate the Telehandler until the seat belt or
mounting hardware is replaced, if worn or damaged.
• The seat belt MUST be worn while operating the
Telehandler. Failure to wear the seat belt could result in
death or serious injury.
The Telehandler is equipped with a standard two inch (2") wide
retractable seat belt. A three inch (3") wide retractable seat
belt is available where required by local laws and regulations.
Figure 22. Retractable Seat Belt
DO NOT adjust the seat or seat belt while the
Telehandler is moving. Keep both hands on
the wheel while the Telehandler is moving
to prevent loss of Telehandler control which
could result in death or serious injury.
Before starting the engine, adjust the seat for position and
comfort (refer to the Operator Seat section of this manual) and
then adjust the seat belt as follows:
1. Grasp the free end of the seat belt (located on the left side
of the seat) and make sure the belt webbing is not twisted
Warning
Warning
or entangled in any portion of the seat assembly.
2. Pull the retractable seat belt across your lap. Position the
seat belt as low on your body as possible.
3. Insert the latch plate into the buckle (on the right side of
the seat) until a "click" is heard.
4. Make sure seat belt retracts snugly across your lap.

Rear View Mirrors

Two (2) adjustable rear view mirrors are provided to aid the
operator's rear vision. One (1) rear-view mirror is mounted on
the upper left of the operator's cab.
Figure 23. Cab-Mounted Mirror
One (1) rear-view mirror is mounted on the right side of the
chassis.
Figure 24. Chassis-Mounted Mirror
35 Operation Manual