Table of Contents
Advertisement
XR630
Backrest Angle Adjustment Lever
Pull the backrest angle adjustment lever up to release the seat
backrest lock. Adjust the angle of the backrest and release the
lever to lock the backrest to the desired angle.
Fig 17. Backrest Angle Adjustment Lever
Fore and Aft Adjustment Lever
Pull the fore and aft adjustment lever outward from the seat
to release the seat lock. Slide the seat forward or backward to
a comfortable location and release the lever to lock the seat in
the desired position.
Fig 18. Fore and Aft Adjustment Lever
Operation Manual
Seat Belt
Always check the condition of the seat belt
and mounting hardware before operating
the Telehandler. If the seat belt or mounting
hardware is defective, it may not properly
restrain the operator, which could result in
death or serious injury.
•
DO NOT operate the Telehandler until the seat belt or
mounting hardware is replaced, if worn or damaged.
•
The seat belt MUST be worn while operating the
Telehandler. Failure to wear the seat belt could result in
death or serious injury.
The Telehandler is equipped with a standard two inch (2")
wide retractable seat belt. A three inch (3") wide retractable
seat belt is available where required by state and local laws
and regulations.
Fig 19. Retractable Seat Belt
DO NOT adjust the seat or seat belt while the
Telehandler is moving. Keep both hands on
the wheel while the Telehandler is moving
to prevent loss of Telehandler control which
could result in death or serious injury.
Before starting the engine, adjust the seat for position and
comfort (refer to the Operator Seat section of this manual) and
then adjust the seat belt as follows:
32
Operator Cab
Warning
Warning
Advertisement
Table of Contents
