AGP CG150 Original Instruction page 8

GB
TO ADJUST THE DEPTH OF CUT
Depth Adjustor
Turn the depth adjustor wheel to the desired depth of cut. Note that
the actual depth of cut will decrease slightly as the diamond blades
wear.
CAUTION: For deep cuts in hard materials, it is recommended to
pre-cut about 20mm before performing the final full depth cut.
This will be faster, more efficient and less stressful to the motor.
VACUUM DUST COLLECTION
Dust Port
There is a vacuum port provided on the blade cover to collect dust
when operating. Always make use of it. Simply attach the vacuum
cleaner hose to the vacuum port.
STARTING AND STOPPING TOOL
To switch on:
This machine has a lock-off type switch. First press the trigger release,
Switch Trigger
then squeeze the trigger switch to switch on. For safety reasons, the
Trigger Release
switch is not possible to lock on.
To switch off:
Release the trigger switch to stop the machine. After the machine has
been switched off, the blade will still rotate for a time, take care that
parts of your body do not come into contact with the blade while it is
still rotating !
LOAD WARNING, OVERLOAD PROTECTION AND OVERHEAT PROTECTION
Load Warning Light:
Whenever the unit is plugged in, the light will be lit solid green.
When the load on the motor is in the maximum range, the light will flash red.
When the motor is overloaded or overheated, the light will be lit solid
Load Warning Light
red.
Load Warning Function:
When maximum load is exceeded, the load warning function will
operate, causing the motor to pulsate. When this happens, the operator
should decrease the force on the tool, and it will return to normal
operation automatically. If the load is not decreased, the motor will shut
8